G32 shifts XY home position?

If I home XYZ then G0 x0 y0 and mark this spot then do a G32 S0 and then do a G0 x0 y0 it goes to a different spot (~x17 y5 with respect to the first home).  I can’t figure out why.

Thanks
Todd

latest firmware ( downloaded 7/21/18) on a Mendel max clone

Comments

  • Try a T0 before homing and see if it differs then. Homing sets the current tool offset and that can change homing position, also after G32 the previous offset should be restored.
Sign In or Register to comment.