Anet A8 Firmware 0.92.9 Ready to use solution
Hi, I know many users has problem with configuration and upload of Repetier for popular Anet A8 3D printers.
1 year ago I made configuration for typical Anet A8 with 5 buttons LCD. Firmware has been tested by 2K people comunity in Poland with very good feedback. Pack included preconfigured Arduino ( you do not need to install it. just run ) with all necesseary libs. Anet v1.0 board is visible in Boards list. You can download it here: https://drive.google.com/open?id=0BwXJ8Kr29Q9VVldUZzVjUldhM2s
This configuration has been tested on many A8 with all types of boards, however remember you are using it at your own risk.
1 year ago I made configuration for typical Anet A8 with 5 buttons LCD. Firmware has been tested by 2K people comunity in Poland with very good feedback. Pack included preconfigured Arduino ( you do not need to install it. just run ) with all necesseary libs. Anet v1.0 board is visible in Boards list. You can download it here: https://drive.google.com/open?id=0BwXJ8Kr29Q9VVldUZzVjUldhM2s
This configuration has been tested on many A8 with all types of boards, however remember you are using it at your own risk.