Problem with swapping E0 for E1 (TEVO TARANTULA MARLIN 1.1.x)

Googoogoogoose

I've already tried everything that the online community tells me to do to solve this problem, but that all doesn't help me. Almost everyone is saying that i just have to swap these lines of code and it will work, but it's not working. Any ideas ?

By the way E0 is not working because i've burnt a pot on it

extruder marlin tarantula

RAyWB

If you want To replace E0 by E1 to make E1 work as E0 just swap the numbers.

so there shoul be :

#define E1_STEP_PIN 26

#define E1_DIR_PIN 28

#define E1_ENABLE_PIN 24

#define E1_CS_PIN 42

and

#define E0_STEP_PIN 36

#define E0_DIR_PIN 34

#define E0_ENABLE_PIN 30

#define E0_CS_PIN 44

Just swapping numbers of CS doesnt help

Googoogoogoose

RAyWB said:

If you want To replace E0 by E1 to make E1 work as E0 just swap the numbers.

so there shoul be :

#define E1_STEP_PIN 26

#define E1_DIR_PIN 28

#define E1_ENABLE_PIN 24

#define E1_CS_PIN 42

and

#define E0_STEP_PIN 36

#define E0_DIR_PIN 34

#define E0_ENABLE_PIN 30

#define E0_CS_PIN 44

Just swapping numbers of CS doesnt help

On the picture above the pins are already swapped

shearder

Just swap the wires on the board