› ›

G32 Speed settings

zyrrzyrr
in Questions & Answers
Hi!

I am trying to setup my Delta Kossel with 092.2 installed. When I issue G32 S2 the printer homes as expected with good speed.

But when the extruder moves down towards the bed it moves with a very slow speed.

How do I change the speed the printer goes down to the bed? I tried changing Z_PROBE_SPEED from 2 to 20 and then 1000 but nothing changed. Is there a setting I have omitted somewhere?

Best Regards,
Conny

Comments

  • zyrrzyrr
    Problem solved, I had EEPROM_MODE 1 in firmware and uploaded from Arduino. I did not notice that I could change it in EEPROM.
Sign In or Register to comment.