Z-Probe issue
I am using .92.9 and have an issue with auto bed leveling. I am using Z-max y-min and x-min end stops and when I home and bring z down to the surface it is at 0,0 of the printable surface. The z-probe is front mounted and I have -20 set for my z_probe_y_offset. When I execute the G29 or G32 command the Z lowers and when it reaches Z_PROBE_BED_DISTANCE the bed moves the opposite way you would expect to the x/y limit switches and crashes the nozzle. I have looked over and over at my setting but can't seem to see where I am going wrong. Any ideas?