Extruder only operates in manual mode after fresh install.
At first, I thought it was a Slicer problem, so I posted this under Slicer. However, since I am still a novice, I thought perhaps I should ask over here as well. Rather than spam the same post over here, I included a link to the other. Any and all help is greatly appreciated.
https://forum.repetier.com/discussion/4626/extruder-only-extruding-in-manual-mode-after-fresh-install
https://forum.repetier.com/discussion/4626/extruder-only-extruding-in-manual-mode-after-fresh-install