Toggle navigation
Categories
Discussions
About Us
Privacy Policy
Sign In
Home
›
Repetier-Firmware
›
Extruder & Bed
Baby stepping after g32 and changing zmax
Morris
November 2017
in
Extruder & Bed
It appears that baby stepping doesn't work if you do G32 s2 then change zmax to compensate for a slightly incorrect zprobe difference. Is that true?
Comments
Repetier
November 2017
If you have baby stepping enabled it always works. Of course any homing like move will remove all done baby steps, but you should be able to readjust after homing again.
Sign In
or
Register
to comment.
Comments