› ›

Auto Level - manual probe deployment...

dan0hdan0h
in General
So after a little experimentation I got the self level to work pretty well, but, I am using a Geeetech G2 Pro with a manually deployed allen-key type probe, so once I'm all done with a G29 command, I stow the probe, go to home the printer and find it won't home any more, as the Z Min switch is then active... is there a toggle in the firmware to tell the printer I have a manually deployed/stowed probe? Or am I missing something obvious in the setup?

Thanks, and sorry if this has been covered before, I couldn't find anything upon a search. :)

Comments

  • RepetierRepetier
    WHat firmware are you using? Repetier-Firmware uses G32 for autoleveling, but z min homing is normally only possible with z-probe as z-min endstop, but that would not work with manual deployment. So you should use z max endstop then instead.
Sign In or Register to comment.