List of Repetier supported G & M Codes

I the list of G & M codes supported by Repetier at http://reprap.org/wiki/G-code up to date or is there one maintained by Repetier on a support page somewhere?  Specifically, I was wondering if "G130: Set digital potentiometer value" is supported.  The page says Repetier does not.  True?

Comments

  • Check repetier.ino in sources for full list. But no G130 is not implemented as far as I know. We support some digital potentiometer types for motors.

    - M908 P<address> S<value> : Set stepper current for digipot (RAMBO board)

Sign In or Register to comment.