I can not load the firmware for the card

CharFbi · August 2017

I have a prusa that I recently modified the height, but the EPROM of this firmware was not recorded, so I need to re-record the card with the new values.

After having compiled in the arduino ide, it is in eternal upload without any notification of success.

Image: https://forum.repetier.com/uploads/editor/cq/6urff402928e.png

Repetier · August 2017

Sure you have selected the right processor. In image I see Atmega644P and most boards use Meag2560.

I can not load the firmware for the card

Comments