z min z Probe not acting same
Hi All
I am trying to configure a RADDS board with a z min and z probe as same on the same pin.
I cannot get the unit to home on z.
when I use M119 my min z is always low while my z probe will change depending on position of the bed.
z probe is configured to z min pin
z probe is a conductive sensor
Wayne
I am trying to configure a RADDS board with a z min and z probe as same on the same pin.
I cannot get the unit to home on z.
when I use M119 my min z is always low while my z probe will change depending on position of the bed.
z probe is configured to z min pin
z probe is a conductive sensor
Wayne