› ›

Tower Position Correction

PingskiPingski
in General
Hi, recently i'v done delta calibration made by someone that is posted on thingiverse, so i've figure out that my tower position is a bit off, the X-Z tower angle is 119.5 degree, and Y-Z tower angle is 119.5, how do i correct this in eeprom settings?Thx :)

Comments

  • RepetierRepetier
    Just change the angle where the tower is. Take one as reference and add/subtract 0.5 for the other towers
  • PingskiPingski
    So in my case i just have to change the Alpha A (X Tower) to 209.5 and Alpha B (Y Tower) to 330.5, is that right? thx 4 answering
  • RepetierRepetier
    Yes, something like that is what i meant.
  • PingskiPingski
    Ok, thx very much 4 helping :)
Sign In or Register to comment.