Hi, When I try homing the bed or x axis, it hits the endstop and keeps on going, any ideas on why this happens, I've checked the wiring and its all fine!
Test if firmware is configured correctly with M119 which shows endstop status. Test manually to see if it changes. For example if you home x to left you must have z min endstop triggering at that side.
Test if firmware is configured correctly with M119 which shows endstop status. Test manually to see if it changes. For example if you home x to left you must have z min endstop triggering at that side.
How can I configure this? Where abouts is it in the code?
Comments