Z axis unwanted offset
I've been struggling with this for almost three days now. I have a Prusa I3 rework (not original prusa), was running repetier 0.91.x and it was printing just great. Until I decided to upgrade to 0.92.9. After long hours I could make the endstops work correctly, but now I have some offset on the Z axis that's really annoying. When I go G28, it works just fine homing, but then the Z goes like 4mm up. I've checked on the configuration.h tab the values I considered relevant. These are:
FYI: I don't have any autolevel, I just do it manually.
Thank you just for reading me