› ›

GUI coordinates not updating after G92 and M114 (V1.6.2)

funbobbyfunbobby
in Bug Reports
I use G92 to manually set the current Z position.
I then use M114 to get the new coords from the firmware
The Repetier Host log correctly shows the new coordinates and the printer LCD shows them correctly, but the Host Manual Control GUI does not update.

Comments

  • RepetierRepetier
    Host shows always absolute position so it adds the G92 offset to M114 response so to speak. Only in CNC mode the host does not do this.
Sign In or Register to comment.