RepRap Full Colour LCD not working
I've been using my 3D printer for over a year and has been very reliable. I recently decided to given the repitier firmware a try instead of marlin. After uploading the firmware to the rumba, the printer goes into a reboot loop with the LCD giving off a beep. I can connect to repiteir host, but just states the printer was reset.
The LCD shows the repitier logo, company and printer name, before refreshing blank every 2 seconds.
The printer is working without the screen
After digging around, I found disabling the LCD gets the printer to boot. What can the issue be? The only change is the firmware.
Comments