Proofread needed for G/M codes in reprap.org
I've updated the big cheat sheet of Gcodes on reprap.org. These values were poorly documented in Repetier.ino, and spottily described in the Repetier Firmware Z-probing tutorial. I dug into the sources and found the real behaviors as best I could.
Someone with better knowledge, please review the edits and adds I made in these RepRap Gcode documentation sections:
http://reprap.org/wiki/G-code#G29:_Detailed_Z-Probe
http://reprap.org/wiki/G-code#G31:_Set_or_Report_Current_Probe_status
http://reprap.org/wiki/G-code#G32:_Probe_Z_and_calculate_Z_plane
http://reprap.org/wiki/G-code#G33:_Measure.2FList.2FAdjust_Distortion_Matrix
http://reprap.org/wiki/G-code#M320:_Activate_autolevel_.28Repetier.29
http://reprap.org/wiki/G-code#M321:_Deactivate_autolevel_.28Repetier.29
http://reprap.org/wiki/G-code#M322:_Reset_autolevel_matrix_.28Repetier.29
http://reprap.org/wiki/G-code#M323:_Distortion_correction_on.2Foff_.28Repetier.29
Comments