Toggle navigation
Categories
Discussions
About Us
Privacy Policy
Sign In
Home
›
Repetier-Host
your printer has asked for a break
boubouexpress
May 2016
in
Repetier-Host
repetier host displayed after M321 and G28
your printer has asked for a break
Comments
Repetier
May 2016
Please check the log. I guess G28 failed switching endstops as expected. Maybe you are not moving enough away from endstops.
boubouexpress
May 2016
hello
if I'm already home the G28 fails
Repetier
May 2016
What does M119 say after homing. All endstops should be low since you are supposed to go down after hitting them.
#define
ENDSTOP_Z_BACK_ON_HOME 30
That gives also room for selecting excentirc extruders which seems your main problem and I think, also I mention this a few times, you still have not set this value.
Sign In
or
Register
to comment.
Comments