rim stutter, but after that its going even faster

oke so the problem (or strange behaviour) i have is as follows 

the rim is stuttering at a speed of 91 mm/s 
the first layer is going smooth with a speed around 60 mm/s 
after that its going with a speed of 100 mm/s (infill around 150mm/s) and no stutter

i think it has something to do with the calculation of the bedleveling and that the arduino cant keep up, but lowering the segments/s while printing or lowering the computation update from the z leveling correction doesnt affect it at all 

i was wondering if any had or experienced the same problem (or wrong configuration).

Sign In or Register to comment.