How to access EEPROM autolevel data?
I got a Davinci 1.0A running Repetier Firmware 0.92!
After an hour of hair-tearing trying to get the bed leveled with the automatic funktion I changed to the manual process using a sheet of paper, that worked fine. But I did a mistake by writing data to the EEPROM in the automativ funktion. Now I've noticed Z-plane micromovements on the stepper motor from the failed automatic calibration, trying to level the bed. I thought that there must been an place in the EEPROM where these data are stored so I tried to access them in order to set them to zero. To my surprise there are not data entries ...? Where are these Z-level data stored?
Thanks for your help!
After an hour of hair-tearing trying to get the bed leveled with the automatic funktion I changed to the manual process using a sheet of paper, that worked fine. But I did a mistake by writing data to the EEPROM in the automativ funktion. Now I've noticed Z-plane micromovements on the stepper motor from the failed automatic calibration, trying to level the bed. I thought that there must been an place in the EEPROM where these data are stored so I tried to access them in order to set them to zero. To my surprise there are not data entries ...? Where are these Z-level data stored?
Thanks for your help!