Print Quality Test Generator
Hello,
I have been trying to perform some pressure advance calibration as i print with very large nozzles at times (1.2mm) and it is hard to get extruder to keep up with initial print moves (i have to set acceleration to extremely low numbers 250 - 300 max)
I am unable to get to the test generator via the menu mentioned in this guide:
https://github.com/repetier/Repetier-Host/wiki/Test-generator
is there some settings within the printer firmware that will make that now accesable that i have missed?
I have been trying to perform some pressure advance calibration as i print with very large nozzles at times (1.2mm) and it is hard to get extruder to keep up with initial print moves (i have to set acceleration to extremely low numbers 250 - 300 max)
I am unable to get to the test generator via the menu mentioned in this guide:
https://github.com/repetier/Repetier-Host/wiki/Test-generator
is there some settings within the printer firmware that will make that now accesable that i have missed?