Square bounding box for circular printer
When printing a part on my Delta printer, I get a warning that the model is too large to print. However, this is not the case.
It seems that the warning is created because the software assumes a square bounding box for the model, while the printer is circular.
Is there any way to overcome this?
If possible I still like to see the warning when it is actually outside my printable area.
It seems that the warning is created because the software assumes a square bounding box for the model, while the printer is circular.
Is there any way to overcome this?
If possible I still like to see the warning when it is actually outside my printable area.
Comments