›

Bltouch erroring on second probe attempt

Todd987Todd987
in Repetier-Firmware
The issue I am having with my generic bltouch is that it can probe with 1 repetition fine but when it tries to do 2 it fails.  I think the problem is that the bltouch is redeploying too soon and dragging itself to the new probe spot before it can raise the z axis up high enough and causing it to error(blinking)

Comments

  • RepetierRepetier
    Yes that is normally the issue and maybe you are not going high enough. For repeated measurements there is a different distance to go less high after triggering. Makes sense with hal sensors but here you must go high enough to not trigger it on deploy. Also z up speed must have a minimum speed for that reason. Video is not working, but these are the typical issues. Try searching forum for working settings, there are lots of threads with bltouch.
Sign In or Register to comment.