Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Motor Control
Homing and pure z motion is smooth but x/y is very jerky
Set X/Y origin correctly with Firmware
Motor Steps/mm configuration
Z-Probe-Trigger has no effect on Motor Control
[Delta] Individual steps per mm settings for X, Y and Z-axis
Slow speed with G0/G1
The Mysterious Disappearaing Endstop
I print oversize
Z axis over travel
the Z-axis motor vibrates when returning home position
Weird Stepper Motor Behavior
Extruder no life :)
Double Distance after Back_on_home
Z Axis not working
X-axis homing has too large of a retraction
Extruder 1 and 2 Stepper Not Moving - Axteeg X3 Pro board
Z-probe Height vs Max z-probe bed dist in EEPROM Setting
Assistance with autolevel on delta. process wont complete, errors in terminal about illegal values.
Endstop triggers in only one direction?
X-motor homes in the wrong direction (Borlee A602)
« Previous Page
Next Page »
Privacy Policy
|
About Us
