-
Add ZRIB Board
by AndreasMaeder ·inside the RAMPS board definition, I did it above the #ifdef AZTEEG_X3 -
20x4 LCD with repetier 9.2 and megatronics 3.0
by ypkdani ·#ifdef UI_FONT_6X10 -
use of DoubleSerial
by Repetier ·#ifdef DEBUG_PRINT -
use of DoubleSerial
by RAyWB ·#ifdef DEBUG_PRINT -
Backlash compensation
by RAyWB ·#ifdef REDUCE_ON_SMALL_SEGMENTS -
End-stops won't stop motor.
by rcrocket33 ·#ifdef ENDSTOPPULLUPS -
Custom Buttons with UI_KEYS_BUTTON_HIGH/LOW
by 4styler ·#ifdef UI_MAIN -
Laser start
by RAyWB ·#ifdef DEBUG_QUEUE_MOVE -
Laser start
by RAyWB ·#ifdef DEBUG_QUEUE_MOVE -
Safety switch for Laser
by RAyWB ·#ifdef DEBUG_PRINT -
Safety switch for Laser
by RAyWB ·#ifdef DEBUG_PRINT -
Diamond nozzle not heating up, unless...
by justTrying ·#ifdef RAMPS_V_1_3 -
Repetier for K8200
by cosudor ·#ifdef ULTRA_LCD -
No start signal detected- forcing start, Eeprom not accessible in RH.
by cplhendo ·#ifdef ENDSTOPPULLUPS -
Extruder stops extruding
by Malcshour ·#ifdef DEBUG_DRYRUN_ERROR -
Extruder stops extruding
by Repetier ·#ifdef DEBUG_DRYRUN_ERROR -
Firmware update
by Repetier ·#ifdef COMPAT_PRE1 -
Melzi V2.0 with LCD2004 and 5 keys
by Quantec ·#ifdef UI_FONT_6X10 -
serial com error system io ports
by Weedz ·//select font size#define UI_FONT_6X10 //default font#ifdef UI_FONT_6X10#define UI_FONT_WIDTH 6#define UI_FONT_HEIGHT 10#define UI_FONT_SMALL_HEIGHT 7#define UI_FONT_DEFAULT repetier_6x10#define UI_FO -
Extruder motor won't go
by kreto ·#ifdef RAMPS_V_1_3