Recently flashed .92 to my 3 week old Davinci 2.0 Duo (J37 board) and  after going through the entire process, and starting over..

jumped 37 and started over.

Check pins.h lin e893 whcih looks like

#3 TEST: The motor from the beginning was slow the same as the end of the last test -- it went a total of 17mm

No latest dev version (after I wrote this) would do. Make sureEnable JSON formated info output for ESP8266 Duet web interface, PanelDue (JSON_OUTPUT) in config tool is enabled.

Ok on 8MP Noir Raspberry Pi camera you need to use the alternate instructions:

What do you mean with "constant error message..." - I see only one and then everything is ok.

#3  0x000000000059107f in start_wrapper ()

all is ok, i have do a modification in  /etc/rc.local and add  the line for start webcam  at the start /usr/local/bin/mjpg_streamer -i input_uvc.so -o "output_http.so -w /usr/local/share/mjpg-st…

Hi,

It s ok for this , i have a new problem after :

Thanks for your help,

Hi,

I have tried connect fan 1 in the first fan port to? but nothing happens?

Hello All. Hello Repetier,I want to set the laser to HEATER_1, but now the laser is ineffective

What we do is writing /home/eike/.local/share/RepetierHost/composition0.stl positioned where it should be sliced.  -s posx=0 -s posy=0 tells the engine not to shift around the stl file.

delta RADDS driver stepper 128 nema 17 400 steps

I did a complete download\install of the latest firmware 92.9, added this line to my configuration.h:#define FAST_COREXYZ

M502

hello