#set new values

#SFTP/SSH/HTTPS not supported yet, so to use plain FTP/TELNET/HTTP

#######Server/Sensor Config#########ip=localhost

#sdtv_mode=2

https://github.com/OctoPrint/OctoPrint-FirmwareUpdater#stm32flash-installation

#s3gt_translate_tooltip_mini { display: none !important; }

Sketch too big; see http://www.arduino.cc/en/Guide/Troubleshooting#size for tips on reducing it.

https://wiki.ubuntu.com/X/InputCoordinateTransformation#Setting_the_Coordinate_Transformation_Matrix

Sketch too big; see http://www.arduino.cc/en/Guide/Troubleshooting#size for tips on reducing it.

Programa muy grando: visite http://www.arduino.cc/en/Guide/Troubleshooting#size para ver cómo reducirlo.

/home/pi/oprint/local/lib/python2.7/site-packages/pip/_vendor/requests/packages/urllib3/util/ssl_.py:318: SNIMissingWarning: An HTTPS request has been made, but the SNI (Subject Name Indication) exten

#status

#status

This same bug makes my RPI2 unreliable. #sadpanda.

as a response to out of filament sensor being triggered. Only if that gets send by firmware host can detect that it happened. And then if the "fatal error" checkbox is enabled it will also u

For some reason I found when I was using Marlin FW, I had to close RH and reopen it to see the restored/changed parameters. The M20# commands scrolled in the log window and reflected the settings, che

The only way I can fix it is to flash it using the HEX file (I'm following this: http://wiki.bootsindustries.com/wiki/Getting_started_with_the_BI_V2.5#Step_6:_Firmware_.28Critical.21.29)

From raps128 docs:Recommended voltage range: 0.8 to 1.6 V. This corresponds to a theoretical peak engine power from 0.73 to 1.46 A - See more at: http://doku.radds.org/dokumentation/raps128/#sthash.wp

#SSLCertificateChainFile /etc/apache2/ssl.crt/server-ca.crt

Just a remark: For now I will try to use Escher for 4 factors only (endstop positions = bed leveling, delta radius) in conjunction with (#spooky voice#) the thing (#spooky voice off#) you linked earli