zonerobotics

Comments

• Update. I printed the "fan shroud" and switched the fan so that it pulls heat away instead of pushing air towards the heat sink on the extruder. I also retrofitted another heat sink around the tube where the extrude goes in. After all that I get pre…

  in Davinci xyz anything higher than 5mm starts to click and will not extrude, not a clog, not bed level Comment by zonerobotics October 2015
• I'm going to swtich back to pla I just need to add the fan shroud and extra heat sinks. But now the stupid wiring harnas has failed on my x stepper motor, going to ohm out the lines and fix that before I can print the fan shroud and such. I'm really…

  in Davinci xyz anything higher than 5mm starts to click and will not extrude, not a clog, not bed level Comment by zonerobotics October 2015
• Successfully printed two things out of ABS without issue. These printers are tricky because like other complex things they can have more than one thing wrong at a time, so you rule out one thing when in fact you should not have. I dont know how ma…

  in Davinci xyz anything higher than 5mm starts to click and will not extrude, not a clog, not bed level Comment by zonerobotics October 2015
• I have hope again, looks like this might help me ! http://www.thingiverse.com/thing:433113

  in Davinci xyz anything higher than 5mm starts to click and will not extrude, not a clog, not bed level Comment by zonerobotics October 2015
• Uhgh, not a lot of luck. I tried 90c and the print looked perfect but before it even got through the first layer it was clicking/stuck. So I thought maybe if I just slow it down it will at least work. I made everything go at 10mm/s as per my slice…

  in Davinci xyz anything higher than 5mm starts to click and will not extrude, not a clog, not bed level Comment by zonerobotics October 2015
• Thanks Repetier,   I have never tried to lower my temperature. Everything I read made me believe I should make it go higher. I started at 195c and just tried a print recently at 220c, it failed horribly just like the others.   It is red PLA and I …

  in Davinci xyz anything higher than 5mm starts to click and will not extrude, not a clog, not bed level Comment by zonerobotics October 2015