zinktiti
About
- Username
- zinktiti
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
Hello Thanks for this support. In the configuration tools in the page "Features" I deselect the line "Enable fan control (M106/M107) for filament cooling. (FEATURE_FAN_CONTROL)" and it work well. Thanks for the support Regards
-
This is my configuration I rename it in .txt to load it. it need to change it in .h to read it
-
Yes i use the repetier firmware laste version. Sertenly i use it with a bad configurations
-
Hello I progress on the AutolevelingI stack some points. I will try to explain what I do ; I go to a position where I put a tool for the PCBG1 X260 Y270 F1000 After I surch the 0 materialG30 P0 => give a valueG1 Z"the value" F100 After I put the …
-
Thanks for this answer. I will test and give you a feedback RegardsThierry