wilko
About
- Username
- wilko
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
it works, thanks for all your help! Matt
-
XYZ DaVinci AIO XYZ_DaVinci_AIO1 Repetier-Firmware cartesian true false 1 true false false 230400 /dev/serial/by-id/usb-Arduino_LLC_Arduino_Due-if00 true 127 3 0 4 -14.6 209 0 -12.6 208 0 0 …
-
how can i send you the file?
-
Sorry i did mean the start script in simplify. I do however have a cancel script in the server and this does not run if I hit stop button and then I get a disconnect message from the server. Thanks for your help
-
if i print same code from simplify3d it works ok and if if put code on sd an print direct on printer it works ok
-
I am using simplify3d GCode: G90M82M106 S0M140 S60M190 S60M104 S195 T0G21 ;metric values G28 ; Home extruderG1 Z15.0 ;move the platform down 15mmG92 E0 ;zero the extruded lengthG1 F200 E4 ;extrude 4mm of feed stockG92 E0 ;zero the extruded length ag…
-
Just to reiterate everything works with 0.75 and nothing else has changed except the server was upgraded to 0.8
-
I think cm_printer and I are talking about the same thing. Printer heats up bed and extruded and then gets stuck in loop. Nothing else happens start script etc. If I try the stop button to cancel the end script is not run either.