venkatesh_edward
About
- Username
- venkatesh_edward
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
I have same issue As soon as i connect to Ramps Board and open Repetier Host It shows extruder as 299.4 'c I haven't heated the extruder In log its showing as Disabled all heaters due to detected sensor defect...
-
Thanks a lot,i checked and found out current was too high as 1.5 Amps I solved issue
-
My actual situation when i assign the E0 port to X-axis intially its not rotating,later i tried by manual input G1 X20 F200 after few sec that means after 10-15sec X-axis(E0 port) Motor starts with clicking sound,A4988 driver became very …
-
With M302 S1 G1 E10 F200 the extruder just tricks as lik energing but not rotating
-
i run with dry run with manually controls but motor is not getting energies
-
I done with M302 S1 even though i cant run extruder motor I am using A4988 driver, its in good condition
-
hi can any one suggest I too facing with same error (EXTRUDER MOTOR NOT WORKING)R-H0.92
-
MartinH said: Did you heat up the nozzle ? Firmware prevents the extruder motor from moving if the nozzle temp is below about 150 C You can override this by sending a M302 (allow cold extrusion) command to the printer no even with cold ext…