unf0rg0tt3n
About
- Username
- unf0rg0tt3n
- Joined
- Visits
- 16
- Last Active
- Roles
- Member
Comments
-
When homing to home all: X is right Z is top Y is back Y is correct according to the image. Z has to go down and X has to go left (at least according to the image and what it was in stock). Movement is easy regulated, the endstops aren't registeri…
-
RAyWB said: as we see, movement directions are ok on all axis , and from looking at the config and also the x-endstop is working firmware setup seems ok. what about the wiring of endstops? is that ok? Doesn't the Z axis has to go dow…
-
X+ is moving Right Y+ is moving to Front (towards the printer front) Z+ is moving Up My config: /* This file is part of Repetier-Firmware. Repetier-Firmware is free software: you can redistribute it and/or modify it under the terms o…
-
RAyWB said: yes, that´s whati wroterotate x-motor and both z-Motor So now: X-Home is moving right - endstop is working Z-Home is moving down - endstop not working Y-Home is moving back - endstop not working But doesn't my endstop Z minu…
-
RAyWB said: Right, i overlooked that last night.so connect the y endstop to y-min Input and reconfigure endstopalso rotate x-motor and both z-Motor connectors by 180 degrees andChange the Settings to:#define INVERT_X_DIR 0 #define INVERT_Y_DI…
-
MartinH said: With the Y endstop at the back of the bed, that is a Ymin endstop. So X0 Y0 puts the nozzle at the Front left corner of the bed Aha, that's why the bed is crashing at the back.
-
X is moving to the right Y is moving backwards Z is moving upwards Z homing is moving upwards, so I need to reverse that I also have my display installed.
-
Awesome! Go Europe! Thanks for all your help this far, really appriciate it
-
Yes. Directions are correct. Except of X which is moving to the right instead of original, but X is actually triggering now. So I have to rotate the endstop to let it trigger on X-min. The endstops aren't triggering. It's late where I …
-
As the one I had to rotate for the Z motor ?
-
now X is going to the right and stops. Then Y is moving back and crashes to the back. Z minus is working properly. My endstops are connected to: X - max Y - max Z - min
-
RAyWB said: first of all some basics: front left is xmin, ymin z-homing shortest distance from bed to nozzle is z-min so - when homing the X carriage is crashing on the left side. homing direction is set to xmin.... max x endstop is…
-
RAyWB said: turn the one which is spinning the wrong direction Thanks! That works now still got lots of issues, such as: - Nothing is heating; Decoupled error. - My max Y and max X endstops arent functioning for some reason. - when hom…
-
RAyWB said: just rotate the plug of one z- motor 180° does it matter which one?
-
Repetier said: Only thing you change is steps per mm to match the high step number. The number of microsteps is set on the board by switches. The steps per mm can be change din eeprom directly, no need to recompile. Awesome!! So my configura…