tmash
About
- Username
- tmash
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
Repetier said: Yes, got kernel headers being too new. rpi-update updated it and now installed version is newer then headers. So it is just a pain to get it matching. Could of course force rpi-update to use special version. But since I have no…
-
Repetier said: Tried to install tty0tty but failed. No matching headers for kernel so it refuses to load the module. But I'm happy it works for you and it is good to know communication works fast and stable with klippy. So it really depends o…
-
Rossini said: Repetier said: If it gives some hints it would be in /var/lib/Repetier-Server/logs/server.log where it normally logs every connect/disconnect as well. Looking into klippy sources I found that this creates the port:# Supp…
-
This is what I get after being connected but it doesnt affect the print: 23:27:18.860: Firmware was halted, trying to reconnect. Eventually running print is stopped.23:27:19.872: !! Printer is halted23:27:19.872: Response while unconnected:ok23:30:…
-
since I can't edit anymore, use cat not echo hehe, was just too excited
-
Welp I can't believe how easily it worked. Didnt use any hardware, just install tty0tty module, then do: echo /tmp/printer > /dev/tnt0 & echo /dev/tnt0 > /tmp/printer Then type in Repetier host serial port: /dev/tnt1 Done! Works perfectly…
-
Thanks for all the effort. Ill manage to tinker with mirroring klipper to external mcu with direct serial (rpi gpio to arduino direct serial), then connect the arduino to rpi via usb with serial mirror sketch or rpi serial loopback with bitbang meth…
-
Just registered for this, Octoprint is too slow for small segmented lines on large prints, Repetier worked fine with smoothie same gcode without stutter, now using klipper (much better for printing large circles on 15~ inch printer), but octoprint s…