› ›

thepoynt

About

Username
thepoynt
Joined
Visits
2
Last Active
Roles
Member

Comments

  • That seems to have done the trick - thanks! Though at the same time I tried printing off the SD card, so maybe it was a communications error.
    in Print stops after a few seconds Comment by thepoynt December 2018
  • Similarly, every once in a while, a manual command goes awry. Once I sent a manual command to increase Z by 1mm, but it just kept going and going until I hit reset on the board. This is the last few lines of Gcode in the file before the last failur…
    in Print stops after a few seconds Comment by thepoynt December 2018