› ›

thedude

About

Username
thedude
Joined
Visits
0
Last Active
Roles
Member

Comments

  • MartinH said: 62 mm to the left, so try #define Z_PROBE_X1 70#define Z_PROBE_Y1 20#define Z_PROBE_X2 250#define Z_PROBE_Y2 20#define Z_PROBE_X3 70#define Z_PROBE_Y3 250 these can be edited in the eeprom via repetier hosts eeprom config tool…
    in Help with BLTouch Comment by thedude September 2018
  • MartinH said: Hi. Couple of things i notice. #define Z_HOME_DIR 1 ; set to -1 for Z min homing. You have Z homing set to Z max, is this correct as you have the Z probe using Z min pin set, and no Z max endstop defined. #define Z_PROBE_PIN…
    in Help with BLTouch Comment by thedude September 2018
  • Here is a video. You can see I can manually drop and raise the pin but Z homing doesn't work. The pin never drops Also, you can hear a change in speed from slow too fast when the bed starts to raise. Why is this?
    in Help with BLTouch Comment by thedude September 2018
  • /*    This file is part of Repetier-Firmware.     Repetier-Firmware is free software: you can redistribute it and/or modify    it under the terms of the GNU General Public License as published by    the Free Software Foundation, either version 3 of …
    in Help with BLTouch Comment by thedude September 2018