sysphp

Comments

• I had the same problem but i could detect that my ~/.mono/registry/CurrentUser/software/repetier/3d/values.xml didn't have permission

  in Not displaying 3D Model preview Comment by sysphp August 2020
• Repetier said: If you home using z probe use order with preheat so you can set a probe point. it was that! Is this documented somewhere? because I could not find this detail in another place.

  in Even being correct, activating z-probe would lead to forbidden xy position Comment by sysphp April 2019
• Sorry but i can't upload the pic. There is my machine: https://imgur.com/a/mqJQmOo MartinH, sorry but I expressed poorly. In the photo, the hotend is approximately at x100: y70 therefore, the 3dtouch is at x139: y49 as I understand. And my Home x p…

  in Even being correct, activating z-probe would lead to forbidden xy position Comment by sysphp April 2019
• How is the link to configure the dev version?

  in Autoleveling error, Nozzle scratches the bed Comment by sysphp August 2017
• this app repetier.com/firmware/v092/ says the config file (branch develop) is invalid, and the size of the config file is the double...

  in Autoleveling error, Nozzle scratches the bed Comment by sysphp August 2017
• Sorry! my home z is Z MAX, and Z MIN is the probe. i need the dev version?

  in Autoleveling error, Nozzle scratches the bed Comment by sysphp August 2017
• this?

  in Autoleveling error, Nozzle scratches the bed Comment by sysphp August 2017