svake
About
- Username
- svake
- Joined
- Visits
- 47
- Last Active
- Roles
- Member
Comments
-
Thanks for your answer. Starting the motor after M84 is silent. The sound it makes when I connect the board with repetierhost or when I upload a new firmware is as loud as a basedrum. It might have to do with the raps128 motordriver and that the mot…
-
Would it help if I borrow you my old Felix? It will have a due board/radds board and a double mixing extruder. I will need about two weeks to equip it properly. Willich is only 60k from cologne, so I can bring you the printer and fetch it later on, …
-
As far as I know this issue comes when using the autoretract feature with M209 S1. When I understand that correctly then extrusion without moving xy triggers the same like the G10 or G11 commands for retract/extrude, means the extruder retracts / ex…
-
It works, thank you.
-
Thanks Repetier, yes, that is right, it's 6,66mm/s. If I don't use advance then I can go up with the feeder speed until the stepper motor falters, what happens with about 50mm/s?. I have tested this once, but forgotten. So it should be faster then …
-
Hi, I have the same problem as described from Andi in the beginning, but with a Rumba board (ATMega 2560) and a mixing extruder (1/16 stepping mode, 312 Steps/mm). An update to the newest firmware did not bring any change, the extruder(s) are runni…
-
Thank you!
-
That solved the problem. Thank you.