super_nova
About
- Username
- super_nova
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
That totally worked! Thank you so much, that was really frustrating for awhile haha. One last question: on large prints my delta is having a bowl effect, where when the head is in the center of the bed, it's at the correct height, but at the edge of…
-
Or what do you think the next course of action would be to find what the actual error is?
-
The max inactive time is in the extruder section and is the maximum time the heater can take to increase temperature, right? If so, I set that to zero in the firmware, but still to no avail. Is there any way to get a more detailed log than what is s…
-
I disabled the heater decouple option but still no luck, is there any way to get a log directly from the firmware to try to debug it?
-
I checked out the log but it doesn't show anything really illuminating to me. I see that the command gets sent to start the bed heater up, then an acknowledgement, then the extruder heater, then an acknowledgement. I then see it calls the temp twice…