spec
About
- Username
- spec
- Joined
- Visits
- 12
- Last Active
- Roles
- Member
Comments
-
Yes, it's works to me too. Thanks :-)
-
I used my config from 0.92.3 to set new one 0.92.8. Maybe this is a problem? Homing is to X min, Y min and Z max and its works. I will check z min after work.
-
Thanks for replay. I have ramps 1.4. Sensor is connected to endstop Z-min S pin (I think that is a pin 18). I don't think that confilct is a problem. I searched configuration.h for 18 and nothing found. I tryed to use:#define Z_PROBE_PIN 18 #define …