› ›

some3

About

Username
some3
Joined
Visits
2
Last Active
Roles
Member

Comments

  • YES this makes the diference. now the temperature is changing like it should. tnx
    in Temperature not updating Comment by some3 January 2019
  • Yes, I'm using inductive sensors as endstops(+ levelshifter to get 5v signals, input signals are ok 0v for low and 5v for high, cofirmed on pin of arduino) therfore I have set the endstop signal sto be "electric normal open" all the inputs for the c…
    in No movmento on any axis, any conditons? Comment by some3 December 2018
  • I'm geting somewhere, in cartesian mode the printer works fine(homing, endswitches, heater) then I set up for delta agen and when i want to home only the Z axis move x and y remain stationary. In manual mode nothing is hapening when I try to move. M…
    in No movmento on any axis, any conditons? Comment by some3 December 2018