smolz

Comments

• managed to get that working by going in and disabling the GL driver (raspi-config ---> advanced options )after reading some other forum posts.  not sure how it got enabled as all I have done is put the image on the card and boot.

  in After update raspberry pi won't completely reboot without hdmi screen attached Comment by smolz September 2020
• Can confirm the same here with both an Ender 3 and 5, both running SKR v1.4 boards.  Both had this error in Console "Dtr: false Rts: false repetier".  Changed RTS / DTR from "LOW to HIGH" to "HIGH to LOW" and both connect up fine now.

  in Unable to connect to printer after Upgrade to 0.94.2 Comment by smolz August 2020
• installs, but now as soon as I start a print the service stops

  in 93.1 update doesn't load on windows Comment by smolz December 2019
• I will give that I try when I get home.  Won’t be for a week

  in Windows 64bit 0.93.1 doesn't start Comment by smolz December 2019
• @Repetier  Can you please send to me also?

  in PRO upgrade Comment by smolz November 2019