smixon9802
About
- Username
- smixon9802
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Couldn't you share the step/direction pins to all stepper drivers and only use separate enable pins to direct a specific stepper?
-
Ok so this is definitely stepping outside the box... I have a Christmas light controller that is capable of sending out 48000 channels worth of data. Each channel is an is an on/off at a given power level. So I know nothing exists but what if s…
-
Reason I am wanting to run so many extruders is for a large multicolor arch building print for an Architect friend of mine. Hoping to get in the door with this to make a little extra $$
-
so what would be the best solution to run say 10 stepper motors. 6 of which are extruders?
-
Led/Resistor positive to pin I am checking and Neg to ground correct?