saxmankk
About
- Username
- saxmankk
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
And, of course, this time it worked. Both cameras captured images through the end of the print and created a video.
-
Both cameras are set at 640x480 and 10fps. If I click into the bolt icon, it currently says "Underpowered: Never" but I can try another dual timelapse and see what happens. In the past, I have gone into the webcam settings and selected "Restart wecb…
-
Ok, I found the issue. I managed to fix it, then get it to break again. I have 1 usb webcam and 1 PiCam connected directly to the board. I removed both and unplugged them. Then, I added each one back in one at a time and tested the timelapse. It …
-
I tried deleting one webcam, and then using the @make_snapshot command you referenced, but it doesn't look like a snapshot was taken. Where would I look to see the image?
-
Alright. Tried a test print after updating, fixed position timelapse every layer. Showed as capturing during print, printhead moved to appropriate location each layer, but only 1 pic in timelapse from before print start. vid was 1 second long and sh…
-
Also, I just updated to 0.94.1 and tried again...same problem.
-
Alright, checked the disk space through ssh and it looks like I should be fine for timelapse. Any other ideas what could be causing this? Here's my current disk usage. I neglected to mention, I have successfully done timelapses in Repetier Server,…
-
Repetier said: Please check if your sd card is nearly full. There is a test to not overflow sd card and recording stops early to prevent problems with full sd card before it happens. It's a 32GB card, but interestingly, my PC only sees it …