renei
About
- Username
- renei
- Joined
- Visits
- 15
- Last Active
- Roles
- Member
Comments
-
I am going to try
-
E2 for second Z2 axe
-
The noise appears only moving from home to any other position eg: x250 y250 z250 (my printer is 500, 500, 500 size with Z and E2 drivers plus two enstops one per Z and E2 axes
-
Finally I have swapped E2 and E1 software pilote , the problem is still there. Finally drivers and sofware pilots have been swapped and the problem (noisy vibration) is still there. In my understanding, the problem should come from the firmware it…
-
Don't you thing some kind of similar G132 feature could be helpful for cartesian printer with Z and Z2 axes and dual Z endstop to mesure relevant axes Z offsets.
-
On my cartesian printer setting M84, G131 G132 function seems to be not available. Am I right ? I am wondering if G131 and G132 could help to align Z1 and Z2 and measure the required offsets between Z and Z2
-
Hello, 1- Regarding the drivers I have swapped the drivers on the MONO-Z management version with one driver for both Z1 and Z2 axes and it worked perfectly 2- Micro stepping on the DUAL-Z management version Both Z1 and Z2 are using DRV8825 drivers …
-
Hello ... I guess the issue is solved. You were right, its just a warning with the version 1.8.0 which does happen with the version 1.0.1. The same firmare V0.9.3 was compiled with both REV 1.0.1 and 1.8.0. Now I am using the firmire 1.0.0 and th…
-
final result with arduino 1.0.1 (in french and is OK) Taille binaire du croquis : 180 596 octets (d'un max de 258 048 octets) message with arduino 1.8.0 (same configuration.h and same directory)
-
Hello, nevertheless I cannot upload the firmware the message I post was just an example