redneckdarrell
About
- Username
- redneckdarrell
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Thanks but I have tried changing the baud rates many times and checked that I have the right port number. Tried clearing the eeprom too.
-
Okay, so what it seems to be doing is the ardruino is connecting with the firmware - when I run the blink - it reads it - and the firmware uploads just fine. When I go to connect with the software - that's what is not connecting for some reason. I…
-
Have tried power down and reconnect as well. Still nothing
-
Hi there, yes t is a mega 2560 with ramps 1.4. I did have it working for one or two runs and then it stopped and started giving me the command waiting. Not sure what changed in between.
-
Thanks - I did try the eeprom clear sketch and then reloaded the marlin sketch, but am still getting the same message - any other ideas?
-
i don't understand the eeprom, I did read that in trying to figure out but I don't know how that works or how to change a value and what to change it to. Can you explain further?