› ›

rbudd22

About

Username
rbudd22
Joined
Visits
47
Last Active
Roles
Member

Comments

  • It just says MonoPrice 3D printer firmware Version 1.0 when it is turned on.  I'm assuming this is a makerbot reproduction but I'm not sure.  I have been researching how some users have updated the firmware to sailfish.  I am somewhat of a newbie wh…
    in Monoprice 11614 software Comment by rbudd22 April 2016
  • Upon further investigation, I realized that the monoprice 3D printer is using the "Replicator Dual" settings.  Has anyone out there been able to run Repetier Host for a Replicator Dual?  If so, where can I find the config download file?  Thank you
    in Monoprice 11614 software Comment by rbudd22 April 2016