printman55
About
- Username
- printman55
- Joined
- Visits
- 0
- Last Active
- Roles
- Member
Comments
-
It is an Atmel Sam3x8e just like the Arduino due. I have connected with the Arduino IDE Serial Monitor with my laptop and I get the same behaviour. I only get output in the Serial Monitor. I can send input, but there are no "ok 0" sent back to me or…
-
Here is the log where I try all combinations. Also as I said, I can write to the MCU by flashing other firmware onto it. Klipper sends back "OK" when I enter a command. It is only Repetier-firmware which does not acknowledge commands, even after rei…