poly3d
About
- Username
- poly3d
- Joined
- Visits
- 80
- Last Active
- Roles
- Member
Comments
-
Finally after few weeks of tries and errors I got the first layer almost perfect! The only problem I experience now is that when printing a 20mm x 20mm tower in "vase mode", I cannot get sidewalls perfectly flat, they seem to have some sort of smal…
-
So I tried using your exact settings and the outcome is unacceptable, I have it printing 1.5mm up in the air between X&Z towers and pushing very hard by the Y tower. Here is a picture of an outline: https://goo.gl/photos/6fxKb9AFG5ZGVCTB9 (hope …
-
Also, I find it interesting that you don't need any endstop offset, even the slightest fraction of a mm might need a few steps. Or maybe my endstops just are not set right, I will see if they all activate at the same time with a nozzle centered out…
-
I'm sorry for getting back late, I'm not getting notified on my email about any updates on this thread, I don't know if that's normal or not. I cannot enlarge the picture, but I can see a thumbnail which definitely looks better than the results I am…
-
I'd love to see the disc! Mine with stock settings is not even possible to print, it prints 2mm high in the air in one spot and dips a lot in the other, so much that it skips teeth. And that's only printing around the perimeter. How is working on th…
-
When I changed the ROD_RADIUS to 176.5 I was getting a dishing effect. 174 is what I measured myself and it took care of the dishing effect. I printed pretty close to a flat plane with 174mm, but when changed to 176.5mm the head would sink approx 2…
-
I got the angles pretty close to what it should be, my only concern is that I have as much as 2.25º correction between two towers and it is a pretty well built printer I believe. I tested the angle correction by printing a single layer giant circle …
-
Thank you, I will take the bending correction out, I thought it could be implemented in deltas. My bed sits on a layer of some type insulation, underneath that insulation are located 3 sensors, I thought that maybe I could fix for the flex in the in…
-
I think that I know where my problem lies but I am not sure how to fix it... I think that dimensions I entered are off by fractions and it keeps me from probing right. I observed that when I calibrated my endstop offsets using a rod, the nozzle wasn…
-
I want to use the height map to have a visual of what the corrected plane looks like after applying the correction so I could compare it with the non-corrected (just like in your video). I notice that after the correction is applied the nozzle lift…
-
I'm having a hard time configuring my printer to make it use a z correction. After I run G33 and it stores the correction matrix in EEPROM I cannot use bed Height map tool, because it probes few spots and crashes, is the correction offsetting the pr…
-
Thank you very much! I will try that tonight!
-
Thank you for the reply. I will try it out today because I didn't have time yet. When it comes to a Z Probe offset, is the offset in XY plane? Or is it a height? My delta uses 3 pressure switches underneath printbed which are connected to a little…