pekkie85
About
- Username
- pekkie85
- Joined
- Visits
- 11
- Last Active
- Roles
- Member
Comments
-
-its m5."You need to set this in eeprom normally which may explain why it has no effect." -how? "If you enable eeprom, you can change the most important parameter after installation over the host. Please be aware that the eeprom values overwrite set…
-
i used this calculator http://prusaprinters.org/calculator/ for my threaded z axis
-
hi,calculating came on 2650, 'normal' mendel settings go around 900mm/sec for Z.but the motor only turns about 10° a sec.10mm in repetier makes 1mm in realtime... we all know they can go faster.but AGAIN. no matter what i give in; 91; 650, 900, 150…
-
hi again.can someone tell me why,no matter wich value is set in the firmware(z-axis-steps per mm) the z axis keeps going stupidly slow.it should be 2650mm/sec, but.... every value gives the same result, and i don't get why.maybe something eeprom rel…
-
did not use the isp. i just went googling for a reset on a melzi. found the reset pin. got hopefull .. M119 showed that endstop y had gotten detached. i was also confused cause the bed moves, not the head (in y dir) have it fixed now. i would share…
-
doubting myself... emergency stop bothered me on the melzi wiki page, http://reprap.org/wiki/Melzithere's a reference to pin 5 on the melzi called reset. for isp uploading via arduino uno."Once the Arduino UNO is an ISP programmer, one can connect i…
-
thnxyet communication still failskill method is set on Reset controller, yet it doesnt react on emergency stop