obor
About
- Username
- obor
- Joined
- Visits
- 29
- Last Active
- Roles
- Member
Comments
-
I got same problem as you, random stop as soon as I touch something near the GPIO pins. It looks to be something with hardware, may be bad ground isolation.. I tried to replace that code with the pigpio library, it allows to better filter when i…
-
it shows white screen for me when i use: http://127.0.0.1:3344otherwise kweb -KEJF http://localhost:3344/mod/front/1024x800/index.htmlworks not too bad, I can see Start and pause buttons at least.
-
My display is : http://www.banggood.com/3_5-Inch-320-X-480-TFT-LCD-Display-Touch-Board-For-Raspberry-Pi-BB-p-958458.htmlResolution: 320x480In index.html, Transform/scale (0.5) instruction did not worked.for me.
-
This would be great. I am currently seeing only half of Repetier -server home page on my Rasp3 + TFT display 5"
-
After having replaced the RAMPS1.4 and motor controller by brand new parts, I still get strange behavior and freeze problems with 0.70.1 and Marlin. The print fails eratically, il seems the head stops for some second (or more) and restart again. …
-
@Repetier Thanks for the hint, i'll check the CPU, may be my WIFI bad connection is eating cpu. Also i discover on my Ramps 1.4 that the solder of heat bed connector on the PCB was getting bad. I resolder it and will try again.
-
thanks for the quick update, 0.70.1 works much better than 0.70.0Well at least during a first 7h print. Tonight, I tried again and after approximately 1hours, it paused erraticaly during the print.Again, and it happen the same way as it did with 0.…
-
ok thanks.
-
Hello, could you please make available previous repetier server versions, right now I am blocked. Thanks
-
Hi Got same pb here with raspberry b2 and v 0.70 Erratic behavior. Logs show comm links errors mis match Checksum. I want to revert to 0.65 but can t find the software anymore on repetier server download home page...